User:Morlit/Ringlock

From Redump Wiki

Latest revision as of 10:33, 25 February 2026

The default parameters of Ringlock should work on most ringed discs. Use the info on this page only if you know what you're doing.

Ringlock Parameters

-c2-size -> The c2 size needed to skip bad sectors (default 2352) (No need to change this currently)
-drive -> Sets the drive used (default "/dev/sr0") (On windows this currently always needs to be used)
-drive-sector-order -> Sets the drives specific sector order (default "DATA_C2_SUB") (Irrelevant if using a Redumper compatible drive)
-lba-end -> Sets the ending position of the disc (Use only if you know which LBA a ring starts and ends. You can change this accordingly to speed things up)
-lba-start -> Sets the starting position of the disc (See above)
-read-type -> Sets the drive used (default "BE") (No need to change this currently)
-retries -> Amount of retries used for narrowing the ring (default 5) (Do not increase this. More than 5 can cause issues for Redumper)
-skip-after-error -> Amount of bad sectors that are allowed before a skip is done (default 10) (No need to change this currently)
-skip-range -> The amount of sector range that is skip (default 20) (20 is the very lowest necessary for every type of ringed DRM. 
 If you know the size of the ring already. You can change this accordingly to speed things up. See also profiles below)
-Speed -> Sets the drives speed (No need to change this currently)

Ringlock Profiles

Laserlock: -skip-range=50
Laserlock Marathon: -skip-range=10
Dinamic/FX: -skip-range=200
RingProtech/ProRing: -skip-range=200
KDG Ring protection (Alcatraz): -skip-range=2000
Sysiphus: -skip-range=100 -retries=0